Pressure Washing Brick

The Dos and Don’ts of Pressure Washing Brick

Pressure washing bricks can be tough. Brick is porous and it will trap dirt, grime, oil, stains and more making it difficult to clean. It’s important to use the right chemicals for pressure washing bricks like a degreaser or specialty cleaner that will dissolve the dirt without damaging your bricks.

You should also take care of any oil or grease with a degreaser before you start to avoid any issues down the line.

The dos of pressure washing bricks:

1. Always use caution when working with pressure washers.
2. Read the manufacturer’s instructions carefully.
3. Test the pressure washer on a small area to make sure it is working properly and that you are familiar with its operation.
4. Wear safety glasses and protective clothing when using a pressure washer.
5. Use the right chemicals for the job – degreasers, specialty cleaners, etc.
6. Pre-soak the area to be cleaned with the chemical cleaner of your choice for best results.
7. Start at the top and work your way down – this will help prevent the cleaner from running off the surface before it has a chance to work.
8. Use a wide-angle nozzle tip to avoid damaging the bricks.
9. Rinse the area thoroughly with clean water after cleaning.
10. Let the area dry completely before applying any sealer or other treatment.

The don’ts of pressure washing brick:

1. Don’t use too much pressure – this can damage the bricks.
2. Don’t use a narrow-angle nozzle tip – this can cause etching and damage to the bricks.
3. Don’t forget to rinse the area thoroughly after cleaning – this will help remove any residual cleaner and prevent it from causing damage to the bricks over time.
4. Don’t clean in direct sunlight – the heat will cause the cleaner to evaporate too quickly, leaving the bricks uncleaned.
5. Don’t let the cleaner dry on the bricks – this can cause etching and damage to the surface.
6. Don’t use a pressure washer for surfaces other than brick – you could damage the surface by using too much pressure or the wrong chemicals.
7. Don’t leave any cleaning solution on the bricks for an extended period of time – this can cause itching and damage to the surface.

8. Don’t use a power washer on areas that are wet or icy – you could slip and fall.
9. Don’t forget to wear safety glasses and protective clothing – the chemicals and high-pressure water can be dangerous.
10. Don’t forget to read the manufacturer’s instructions carefully – this will help you avoid any mistakes that could damage your bricks.

The pressure washing brick process can be tricky to get right, but when you do it will make a huge difference. At the end of all this work, your bricks should look shiny and new with no signs of dirt or stains left behind.

If you’re looking for help with pressure cleaning bricks in your area, give us a call! We have trained professionals ready and waiting to start working on any size project–big or small. No matter what type of material we’ll take care of it so you don’t have to worry about anything at all.

So pick up the phone now and let’s talk more about how we can improve the exterior appearance of your home today!